310 Keysight M8070A Programming Guide
5 SCPI Command Reference
:PLUGin:OTIMing:ACQuisition:OPTimization[?]
Syntax :PLUGin:OTIMing:ACQuisition:OPTimization ‘identifier’, <FTJ|NONE>
:PLUGin:OTIMing:ACQuisition:OPTimization? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<FTJ|NONE>: Specify the sample delay optimization technique.
Return Range FTJ|NONE
Description This command specifies the sample delay optimization technique and
associates it with a specific measurement name identifier. If NONE is
selected then no optimization is performed. If FTJ is selected then the fast
total jitter measurement is performed. The query returns the current value.
This SCPI is applicable for M8041A, M8051A, M8062A and M8046A.
Example :PLUG:OTIM:ACQ:OPT ‘MyMeasurement’, FTJ
:PLUGin:OTIMing:ACQuisition:COMPared[?]
Syntax :PLUGin:OTIMing:ACQuisition:COMPared ‘identifier’, <NRf>
:PLUGin:OTIMing:ACQuisition:COMPared? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<NRf>: Specify the number of compared bits.
Return Range 1E+0 to 1E+18
Description This command specifies the number of compared bits used as criteria for
moving to the next measurement point when the sample delay
optimization is set to NONE. This command also associates this parameter
with a specific measurement name identifier. The query returns the current
value.
This SCPI is applicable for M8041A, M8051A, M8062A and M8046A.
Example :PLUG:OTIM:ACQ:COMP ‘MyMeasurement’, 1E+7
To Next Page
Loading...
Need help?
General
