Keysight Technologies J-BERT M8020A - Page 351

Keysight M8070A Programming Guide 351
SCPI Command Reference 5
:PLUGin:OLEVel:FETCh:LEVel:AMPlitude?
Syntax :PLUGin:OLEVel:FETCh:LEVel:AMPlitude? ‘identifier’ [,‘Location’]
Input
Parameters
‘identifier’: Specify the measurement name.
[,‘Location’]: ‘M*.DataIn1’ or ‘M*.DataIn2’ (optional).
Description This command returns the value of amplitude calculated after a run.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUGin:OLEVel:FETCh:LEVel:AMPlitude? ‘MyMeasurement’
:PLUGin:OLEVel:FETCh:LEVel:HIGH?
Syntax :PLUGin:OLEVel:FETCh:LEVel:HIGH? ‘identifier’ [,‘Location’]
Input
Parameters
‘identifier’: Specify the measurement name.
[,‘Location’]: ‘M*.DataIn1’ or ‘M*.DataIn2’ (optional).
Description This command returns the value of the high level.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUGin:OLEVel:FETCh:LEVel:HIGH? ‘MyMeasurement’
:PLUGin:OLEVel:FETCh:LEVel:LOW?
Syntax :PLUGin:OLEVel:FETCh:LEVel:LOW?‘identifier’ [,‘Location’]
Input
Parameters
‘identifier’: Specify the measurement name.
[,‘Location’]: ‘M*.DataIn1’ or ‘M*.DataIn2’ (optional).
Description This command returns the value of the low level.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUGin:OLEVel:FETCh:LEVel:LOW? ‘MyMeasurement’