Keysight Technologies J-BERT M8020A - Page 357

Keysight M8070A Programming Guide 357
SCPI Command Reference 5
:PLUGin:OLEVel:FETCh:QLEVel:QFActor?
Syntax :PLUGin:OLEVel:FETCh:QLEVel:QFActor? ‘identifier’ [,‘Location’]
Input
Parameters
‘identifier’: Specify the measurement name.
[,‘Location’]: ‘M*.DataIn1’ or ‘M*.DataIn2’ (optional).
Description This command returns the value of the Q factor.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUGin:OLEVel:FETCh:QLEVel:QFActor? ‘MyMeasurement’
:PLUGin:OLEVel:FETCh:QLEVel:QOThreshold?
Syntax :PLUGin:OLEVel:FETCh:QLEVel:QOThreshold? ‘identifier’ [,‘Location’]
Input
Parameters
‘identifier’: Specify the measurement name.
[,‘Location’]: ‘M*.DataIn1’ or ‘M*.DataIn2’ (optional).
Description This command returns the value of the Q Optimum threshold.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUGin:OLEVel:FETCh:QLEVel:QOThreshold? ‘MyMeasurement’
:LOW? :PLUGin:OLEVel:FETCh:QLEVel:LOW? on
page 359
:LOW:POINts? :PLUGin:OLEVel:FETCh:QLEVel:LOW:POINt
s? on page 360
:LOW:RSQuare? :PLUGin:OLEVel:FETCh:QLEVel:LOW:RSQu
are? on page 360
:LOW:STDeviation? :PLUGin:OLEVel:FETCh:QLEVel:LOW:STDev
iation? on page 360
Name Description under