Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 385
SCPI Command Reference 5
:PLUGin:JTOLerance:GRAPh:TLIMits[?]
Syntax :PLUGin:JTOLerance:GRAPh:TLIMits ‘identifier’, <ON|OFF|1|0>
:PLUGin:JTOLerance:GRAPh:TLIMits? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<ON|OFF|1|0>: Enable/disable template limit lines.
Return Range 1|0
Description This command enables/disables the template limits in the graph for the
measurement specified by the measurement name identifier. These limits
show the search range amplitude (UI) during characterization defined
using the template editor in the M8070A software interface.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example :PLUG:JTOL:GRAP:TLIM ‘MyMeasurement’, ON
:PLUGin:JTOLerance:GRAPh:TPOints[?]
Syntax :PLUGin:JTOLerance:GRAPh:TPOints ‘identifier’, <ON|OFF|1|0>
:PLUGin:JTOLerance:GRAPh:TPOints? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<ON|OFF|1|0>: Enable/disable template test points.
Return Range 1|0
Description This command enables/disables the template measurement points in the
graph for the measurement specified by the measurement name identifier.
These test points are defined using the template editor in the M8070A
software interface.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example :PLUG:JTOL:GRAP:TPO ‘MyMeasurement’, ON

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English