Keysight M8070A Programming Guide 439
SCPI Command Reference 5
:PLUGin:CCAPture:DELete
Syntax :PLUGin:CCAPture:DELete ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name to delete.
Description This command deletes a previously created compare and capture
measurement addressed by the measurement name identifier.
This SCPI is applicable for M8041A and M8051A.
Example The following example deletes a compare and capture measurement
addressed by the measurement name identifier called ‘MyMeasurement’:
:PLUG:CCAP:DEL ‘MyMeasurement’
:PLUGin:CCAPture:NEW
Syntax :PLUGin:CCAPture:NEW ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
Description This command creates a new compare and capture measurement name
identifier.
This SCPI is applicable for M8041A and M8051A.
Example The following example creates a compare and capture measurement name
identifier called ‘MyMeasurement’:
:PLUG:CCAP:NEW ‘MyMeasurement’
:PLUGin:CCAPture:RESet
Syntax :PLUGin:CCAPture:RESet ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name to reset.
Description This command resets a compare and capture measurement addressed by
the measurement name identifier.
This SCPI is applicable for M8041A and M8051A.
Example The following example resets a compare and capture measurement
addressed with the measurement name identifier called ‘MyMeasurement’:
:PLUG:CCAP:RES ‘MyMeasurement’
To Next Page
Loading...
