Keysight M8070A Programming Guide 449
SCPI Command Reference 5
:PLUGin:CCAPture:ACQuisition:ALOCation[?]
Syntax :PLUGin:CCAPture:ACQuisition:LOCation ‘identifier’,'Location'
:PLUGin:CCAPture:ACQuisition:LOCation? ‘identifier’
Input
Parameters
identifier: ‘Name of Measurement’
‘Location’: ‘M*.DataIn1’ or ‘M*.DataIn2’
Description Specified the location the compare & capture measurement cooperates
with. Examples for a location are 'M1.DataIn1', 'M3.DataIn2',… or a name
of an existing group of DataIns.
This SCPI is applicable for M8041A and M8051A.
Example PLUGin:CCAPture:ACQuisition:ALOCation ‘My Measurement’,
‘M1.DataIn1’
:PLUGin:CCAPture:ACQuisition:DEPTh[?]
Syntax :PLUGin:CCAPture:ACQuisition:DEPTh ‘identifier’,<NRf>
:PLUGin:CCAPture:ACQuisition:DEPTh? ‘identifier’
Input
Parameters
identifier: ‘Name of Measurement’
Range 0 to 2147483648
Description This command configures how long the capture logic will write the capture
memory after detecting the trigger event.
This SCPI is applicable for M8041A and M8051A.
Example :PLUGin:CCAPture:ACQuisition:DEPTh ‘My Measurement’, 1
:PLUGin:CCAPture:ACQuisition:HOLDoff[?]
Syntax :PLUGin:CCAPture:ACQuisition:HOLDoff ‘identifier’,<NRf>
:PLUGin:CCAPture:ACQuisition:HOLDoff? ‘identifier’
Input
Parameters
identifier: ‘Name of Measurement’
Range 0 to 2147483648
Description Specifies the amount of bits the trigger event is ignored after starting
capturing of data.
To Next Page
Loading...
