Keysight M8070A Programming Guide 475
SCPI Command Reference 5
:DATA:PATTern:CATalog?
Syntax :DATA:PATTern:CATalog? <pattern-path>
Input
Parameters
<pattern-path>: Location of patterns.
Description This command returns a list of patterns found at the specified path.
Example :DATA:PATT:CAT? "factory:XAUI"
“CJPAT_bit,CRPAT_b8b10,CRPAT_bit”
:DATA:PATTern:CINFormation?
Syntax :DATA:PATTern:CINFormation?
<symbol-coding>[,<mask-used>[,<squelch-used>]]
Input
Parameters
<symbol- coding>: BIT|B8B10|B128B130|B128B132 for bit coding, 8b10b
coding, 128/130 coding or 128/132 coding.
<mask- used>: 0|1|OFF|ON to specify if mask attribute is used. Default is
OFF. Not using mask is mostly useful for bit coding to save space.
<squelch-used>: 0|1|OFF|ON to specify if squelch attribute is used. Default
is OFF. Not using squelch is mostly useful for bit coding to save space.
Return Range <symbol-coding>, <mask-used>, <squelch-used>
Description This command returns coding information.
Example :DATA:PATT:CINF? b8b10,on,on
16,"Data",0,7,"K/D",8,8,"Mask",10,10,"Squelch",11,11,"Enable
Scrambler",12,12,"Pause Scrambler",13,13,"Reset
Scrambler",14,14,"Start of Frame",15,15
To Next Page
Loading...
