Standard View
Symbol/Field Description
1 TraceControls Identifies the volt/div. or curr/div. setting. √ indicates the traceis on.
Dashes (----) indicate the traceis off.
Select the traceand press Enter to turn iton or off.
2 Data Bar The data bar represents all of the waveform data that has been collected.
The yellow part indicates the portion of the data thatis visible on the display.
The black part represents the data thatis notvisible.
3 ScopeTraces Voltage tracelabels appear on the leftside of the grid (V1 V2, V3, V4).
Current trace labels appear on the right side of the grid (I1, I2, I3, I4).
Power tracelabels appear on the center of the grid (P1, P2, P3, P4).
If a portion of a traceis red, it means that portion of the traceis outof range. Push the Trigger Level
knob to autoscale the traces. This will trigger a new measurement.
Only Models N676xA and N678xA SMU can display power traces.
4 OutputPop-ups Turning the voltage and current knobs displays a pop-up dialog showing the present output
settings.
Pushing the voltage and currentknobs displays a pop-up dialog allowing the following actions:
• Lock/Unlock the voltage or currentknobs.
• On Models N678xA, select a limit parameter to control or select limit tracking.
5 Out of View Arrows Indicatethatthetrace, V1 in the figure, is outof view.
Use the Vertical Volt/Div knob or the Vertical Offset knob to bring the trace into view.
Push the Trigger Level knob to autoscale the traces. This will trigger a new measurement.
6 Ground Reference The ground referenceof the trace. Ground references areoffset so that they do notoverlap. The
ground reference offset valueis referenced to the horizontal center line of the grid.
4 Using the Measurement Functions
136 Keysight N6705C Operating and Service Guide
To Next Page
Loading...
