Keysight N6705C - Scope View

Scope View
Press Scope
View
This key
toggles
between
standard and
marker views.
Standard View
Marker View
1. Trace
Controls
Identifies the voltageor current tracethatwill be displayed. Dashes (----) indicatethat the specified traceis turned off. Select
the traceand press Enter to turn iton or off.
2. Output
Traces
V1, V2, V3, and V4 indicate voltage traces. I1, I2, I3, and I4 indicate current traces. P1 and P2 indicate power traces. Press
Trigger Level knob to autoscale all traces .
3. Horizontal
Time-base
Identifies the horizontal time-base settings. Thesecan be adjusted using the front panel Horizontal Time/Div and Offset
knobs.
4. Scope
Status
Indicates whether the scopeis idle, running, or waiting for a trigger.
5. Data Bar The highlighted area shows howmuch of the entire measurement is actually shown on the display. Usethe Horizontal
Time/Div knob and Offsetknob to adjust the display
6. Trigger
Level
Identifies the trigger level through which the waveform mustpass before the scopewill trigger. This can be adjusted using
the Trigger Level knob.
7. Ground Identifies the ground reference level for the trace. This can be adjusted using the Vertical Offset knob. The initial vertical offset
of each traceis set to a different level to preventthe traces from overlapping.
8. Trigger
Mode
Identifies the trigger mode setting. This can be selected by pressing the Properties key.
9. Trigger
Source
Identifies the trigger source and trigger level. Voltage 1 indicates a voltage level on output1 is the trigger source (see #6).
10. M1 Marker MeasurementMarker 1 enabled. Adjustusing Marker 1 knob. Press knob to reset.
11. M2 Marker MeasurementMarker 2 enabled. Adjustusing Marker 1 knob. Press knob to reset.
12. Intersect
Point
Shows where the measurement markers intersect the waveform.
13. Meas-
urements
Shows the calculations of the waveform databetween Marker 1 and Marker 2.
1 Quick Reference
20 Keysight N6705C Operating and Service Guide