Keysight N6705C - Data Logger and Scope Display Differences

Data Logger and Scope Display Differences
The Scope View and Data Logger displays are similar in many respects, such as the way traces are
displayed, how traces are selected, and the marker controls - to name a few. This similarity makes it
easier to program each function.
However, there are important differences in the Scope and Data Logger displays that may not be
obvious at first glance. To help eliminate confusion when using both Scope and Data Logger, the
following table lists the major differences in the display functions.
Function Scope View Data Logger
Graph Waveform capture Strip chart
Traceselection Voltage, current, and power traces
- for N676xA and N678xA SMU
power modules
Voltage or currenttrace
- for all other power modules
Continuous mode
Voltage, current, and power traces
- for N676xA and N678xA SMU
power modules
Voltage or currenttrace
- for all other power modules
Interleaved mode
Voltage and current, or power
Trigger level selection Note thatcurrent levels cannotbe selected as trig-
gers on outputs that have been grouped.
Continuous mode
Voltage or currentlevel of selected trace
- for allpower modules
Interleaved mode
Run Stop key only
- for all power modules
Notethat currentlevels cannotbe selected as triggers on out-
puts thathave been grouped.
Trigger mode Auto, single, or triggered Does notapply
Trigger position Turn the horizontal offset knob Press Properties, select Trigger.
Trigger position is specified as a % of the data log duration.
Horizontal trigger off-
set reference
Left, center, or right Does notapply to strip chart
Tracesave Press File, select Save. Automatically saved to default.dlog file
(A different file name can be specified prior to running the data-
log.)
4 Using the Measurement Functions
160 Keysight N6705C Operating and Service Guide