Keysight N6705C - Reset (*RST) and Non-Volatile Settings; Reset and Non-Volatile Settings

Reset (*RST) and Non-volatile Settings
Reset State
Non-volatile Settings
Initial N678xA SMU Emulation Mode Settings
Reset and Non-volatile Settings
The following tables show the reset state. These parameters are set to the indicated values at power-
on or after *RST.
The power-on/reset state may differ from that shown below if you have enabled power-
on state recall mode from the States menu (see Instrument State Storage).
SCPI Command *RST Settings
ARB:COUNt 1 OUTPut OFF
ARB:CURRent|VOLTage:CDWell:DWELl 0.001 OUTPut:DELay:FALL 0
ARB:CURRent|VOLTage:CDWell:LEVel MIN OUTPut:DELay:RISE 0
ARB:CURRent|VOLTage:EXPonential:END MIN OUTPut:PMODe VOLT
ARB:CURRent|VOLTage:EXPonential:STARt MIN OUTPut:TMODe LOWZ
ARB:CURRent|VOLTage:EXPonential:STARt:TIMe 0 OUTPut:PROTect:COUPle OFF
ARB:CURRent|VOLTage:EXPonential:TCONstant 1 OUTPut:PROTect:DELay 0.02
ARB:CURRent|VOLTage:EXPonential:TIMe 1 OUTPut:PROTect:OSCillation ON
ARB:CURRent|VOLTage:PULSe:END:TIMe 0 OUTPut:PROTect:WDOG OFF
ARB:CURRent|VOLTage:PULSe:STARt MIN OUTPut:RELay:POLarity NORM
ARB:CURRent|VOLTage:PULSe:STARt:TIMe 0 POWer:LIMit MAX
ARB:CURRent|VOLTage:PULSe:TOP MIN RESistance 0
ARB:CURRent|VOLTage:PULSe:TOP:TIMe 1 RESistance:STATe OFF
ARB:CURRent|VOLTage:RAMP:END MIN SENSe:CURRent:CCOMmunicate ON
ARB:CURRent|VOLTage:RAMP:END:TIMe 0 SENSe:CURRent:RANGe MAX
ARB:CURRent|VOLTage:RAMP:RTIMe 1 SENSe:CURRent:RANGe:AUTO OFF
ARB:CURRent|VOLTage:RAMP:STARt MIN SENSe:DLOG:CURRent:RANGe:AUTO OFF
7 SCPI Programming Reference
354 Keysight N6705C Operating and Service Guide