User-Defined Parameters
Parameter Description
Step <n> Each step of the waveform includes a voltageor current parameter, dwell time, and trigger option. The
total number of steps determines the length. Use the ▲ ▼ navigation keys to scroll through the steps.
Current or Voltage The current or voltage value of the step.
Time The time thatthe output stays at the step.
Trigger Generatean external trigger signal at the start of the step when checked.
Add Inserts a step below the selected step; values are copied from the previous step.
Delete Deletes the presently selected step.
Clear Clears all steps.
Import(.csv format) Imports a currentor voltageArb list.
Export (.csv format) Exports a currentor voltageArb list.
From the remote interface:
The current or voltage value of five steps:
ARB:CURR:UDEF:LEV 1,2,3,4,5,(@1)
ARB:VOLT:UDEF:LEV 1,2,3,4,5,(@1)
The time that the output stays at the steps:
ARB:CURR:UDEF:DWEL 1,2,3,2,1,(@1)
ARB:VOLT:UDEF:DWEL 1,2,3,2,1,(@1)
Generate an external trigger signal at the start of the step (the trigger is generated at the start of step
#3):
ARB:CURR:UDEF:BOST 0,0,1,0,0,(@1)
ARB:VOLT:UDEF:BOST 0,0,1,0,0,(@1)
3 Using the Source Functions
118 Keysight N6705C Operating and Service Guide
To Next Page
Loading...
