Keysight N6705C - Page 117

Parameter Description
Start Setting (I
0
or V
0
) The setting before and after the trapezoid.
Peak Setting (I
1
or V
1
) The peak setting.
Delay (T
0
) The delay after the trigger is received but before the trapezoid starts.
Rise Time (T
1
) The timethatthe trapezoid ramps up.
Peak Width (T
2
) The width of the peak.
Fall Time (T
3
) The time thatthe trapezoid ramps down.
End Time (T
3
) The time the outputremains at the end setting after the trapezoid completes.
From the remote interface:
The setting before and after the trapezoid:
ARB:CURR:TRAP:STAR 0,(@1)
ARB:VOLT:TRAP:STAR 0,(@1)
The peak setting:
ARB:CURR:TRAP:TOP 1,(@1)
ARB:VOLT:TRAP:TOP 5,(@1)
The delay after the trigger is received but before the trapezoid starts:
ARB:CURR:TRAP:STAR:TIM 0.25,(@1)
ARB:VOLT:TRAP:STAR:TIM 0.25,(@1)
The time that the trapezoid ramps up (RTIM) and down (FTIM):
ARB:CURR:TRAP:RTIM 0.5,(@1)
ARB:VOLT:TRAP:RTIM 0.5,(@1)
ARB:CURR:TRAP:FTIM 0.5,(@1)
ARB:VOLT:TRAP:FTIM 0.5,(@1)
The width of the peak:
ARB:CURR:TRAP:TOP:TIM 1.5,(@1)
ARB:VOLT:TRAP:TOP:TIM 1.5,(@1)
The time the output remains at the end setting after the trapezoid:
ARB:CURR:TRAP:END:TIM 0.25,(@1)
ARB:VOLT:TRAP:END:TIM 0.25,(@1)
Keysight N6705C Operating and Service Guide 117
3 Using the Source Functions