Data Logger View
Option 055 deletes the Data Logger function on Model N6705
Press Data
Logger
This key
toggles
between
standard and
marker views.
Standard View Marker View
1. Trace
Controls
Identifies the voltageor current tracethatwill be displayed. Dashes (----) indicatethat the specified traceis turned off. Select
the traceand press Enter to turn iton or off.
2. Output
Traces
Voltage, current, or power traces. Voltage traces V1,V2, V3 and V4 shown. Press Trigger Level knob to autoscale all traces.
3. Status Indicates whether the Data Logger is logging data, done logging, or is empty.
4. Filename Indicatethe fileto which the data is being logged.
5. Data Bar &
Time Elapsed
Displays the progress of the data logger. The yellow bar indicates the visibledata. Numbers to the right indicate time
elapsed/total duration.
6. Time base
Information
Displays the timeremaining beforethe trigger point; the time at the center line of the grid in relation to trigger point; and the
timeelapsed sincethe trigger
7. Trigger Identifies the trigger source and trigger offset. The trigger offsetis specified in % of the total duration, but shown in seconds
on the display
8. M1 Marker MeasurementMarker 1 enabled. Adjustusing Marker 1 knob. Press knob to reset.
9. M2 Marker MeasurementMarker 2 enabled. Adjustusing Marker 1 knob. Press knob to reset.
10. Intersect
Point
Shows where the measurement markers intersect the waveform.
11. Meas-
urements
Shows the calculations of the waveform databetween Marker 1 and Marker 2.
Keysight N6705C Operating and Service Guide 21
1 Quick Reference
To Next Page
Loading...
