Parameter Typical Return
(none) (none)
Presetthe Operation and Questionable registers: STAT:PRES
STATus:QUEStionable[:EVENt]? (<@chanlist>)
Queries the event register for the Questionable Status group. This is a read-only register, which
stores (latches) all events that are passed by the Operation NTR and PTR filter. Reading the
Questionable Status Event register clears it.
Parameter Typical Return
(none) <bit value>
Read questionable status event register: STAT:QUES? (@1)
l *RST has no effect on this register.
l The value returned is the binary-weighted sum of all bits set in the register.
STATus:QUEStionable:CONDition? (<@chanlist>)
Queries the condition register for the Questionable Status group. This is a read-only register, which
holds the live (unlatched) operational status of the instrument. Reading the Questionable Status
Condition register does not clear it.
Parameter Typical Return
(none) <bit value>
Read questionable status condition register: STAT:QUES:COND? (@1)
l The condition register bits reflect the current condition. If a condition goes away, the cor-
responding bit is cleared.
l *RST clears this register, other than those bits where the condition still exists after *RST.
l The value returned is the binary-weighted sum of all bits set in the register.
STATus:QUEStionable:ENABle <value>, (<@chanlist>)
STATus:QUEStionable:ENABle? (<@chanlist>)
Sets and queries bits in the enable register for the Questionable Status group. The enable register is a
mask for enabling specific bits from the Operation Event register to set the QUES (questionable
summary) bit of the Status Byte register. STATus:PRESet clears all bits in the enable register.
Parameter Typical Return
A decimal value that corresponds to the binary-weighted sum of the bits
in the register.
<bit value>
Enable bit 2 and 4 in the questionable enable register: STAT:QUES:ENAB 24, (@1)
Keysight N6705C Operating and Service Guide 329
7 SCPI Programming Reference
To Next Page
Loading...
