A triggered value is on a different range than the one that is presently set.
306 Too many list points
Too many list points have been specified.
307 List lengths are not equivalent
One or more lists are not the same length.
308 This setting cannot be changed while transient trigger is initiated
Setting cannot be changed while the instrument is waiting for or executing a trigger sequence.
309 Cannot initiate, voltage and current in fixed mode
Cannot initiate transient generator. Either the voltage or current function is set to Fixed mode.
310 The command is not supported by this model
This power modules either does not have the hardware capability or the options required to support
this command.
311 This group of channel has non-identical features
One or more modules in this group does not match the ratings or options of the other modules.
312 The command is disabled when the channel is grouped
This command is disabled when the output channel is grouped.
313 Datalog time interval is out of range
The data log time interval is outside the programmable range.
314 Time of day clock has stopped
The time of day clock has stopped. Replace the internal battery. See Service Guide.
315 Settings conflict error
A data element could not be programmed because of the present instrument state.
316 Mass storage error
The mass storage memory has been exceeded.
317 Invalid format
An invalid data format was found in the command string.
318 Datalog error
An error has occurred in the data returned by the datalogger.
319 Measurement is not allowed while datalogger is running
You cannot make measurements in Meter View or Scope View while the datalogger is running.
Keysight N6705C Operating and Service Guide 363
7 SCPI Programming Reference
To Next Page
Loading...
