Step 7. To install the top chassis, perform steps 1-6 in reverse order. Be sure to tuck all cables in
before replacing the top chassis
Removing/Installing the Bias Board (5067-5202)
Step 1. Remove the top chassis as previously described.
Step 2. Remove three screws using a T10 driver and disconnect five cables.
Step 3. Remove the bias board.
Step 4. To install the bias board, perform the above steps in reverse order.
Removing/Installing the Processor Carrier Board (N6705-66501)
Step 1. Remove the top chassis as previously described.
9 Service and Maintenance
446 Keysight N6705C Operating and Service Guide
To Next Page
Loading...
