EasyManua.ls Logo

Konica Minolta C71cf - Control Panel (Roll Winder RW-101;Roll Winder RW-201); Roll Winder RW-101

Konica Minolta C71cf
143 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-8
1.2 Machine Panel
Control Panel (Roll Winder RW-101/Roll Winder RW-201)
This section describes the control panel of Roll Winder RW-101 and Roll Winder RW-201.
)Roll Winder RW-101
WEB
GRIPPER2
WEB
GRIPPER1
EMG.RESET
READY JOG
STOP
2
1
34
567
No. Name Description
1 EMERGENCY STOP Press to stop this system in case of emergency. Use only in
case of emergency. Pressing EMERGENCY STOP stops the
machine immediately. To reset that emergency stop status,
press EMG.RESET and also turn EMERGENCY STOP to the
right. Do not press EMERGENCY STOP to stop usual printing.
It may result the machine and media being damaged.
2 EMG.RESET When this system stops immediately, clear the error and confirm
the top cover is closed, and then press EMG.RESET to reset
the emergency stop.
3 WEB GRIPPER2 If WEB GRIPPER2 is set to on, the media pressing bar 2 is
activated, if WEB GRIPPER2 is set to off, the media pressing
bar 2 is deactivated. Use to replace the media on Roll Winder
RW-101.
Make sure the button is set to off before printing.
4 WEB GRIPPER1 If WEB GRIPPER1 is set to on, the media pressing bar 1 is
activated, if WEB GRIPPER1 is set to off, the media pressing
bar 1 is deactivated. Use to replace the media on Roll Winder
RW-101.
Make sure the button is set to off before printing.
5 STOP Stops jobs while conveying a paper and printing. Stops the
whole system.
The LED lights up in the emergency stop status.
When Roll Winder RW-101 is stopped, the LED blinks.
•Press STOP while the LED flickers, the LED turns off and the
stop status is canceled.
6 READY Rotate the feeding shaft of Roll Winder RW-101 alone and
convey the media. If READY is pressed while the machine is
stopped and offline, the alarm beeps for three seconds. For five
seconds after the time the alarm stops, JOG is effective.
7 JOG When the machine is stopped and offline, you can operate the
conveyer of Roll Winder RW-101 for five seconds from the time
READY is pressed and the alarm stops beeping. While pressing
JOG, the conveyer operates. Use the function when adjusting
the media.
If JOG is not pressed within five seconds, or STOP
is pressed,
newly press READY.

Table of Contents

Related product manuals