5-16
5.5 A media feeding error occurs
5.5 A media feeding error occurs
This section describes typical media errors and remedies for them.
Take an action as shown below according to each problem.
For details on other errors, refer to the HTML User's Guide.
Problem Remedy
If a Meandering Paper Has Oc-
curred
1. Check the tension setting.
2. Check the positions of the media and parts such as the roller guide.
3. Clean adhesive sticking on the parts.
4. Adjust the position of the aligning roller.
5. Change the tension setting.
For details, refer to page 5-17.
Paper Leans to One Side 1. Check the tension setting.
2. Check the positions of the media and parts such as the roller guide.
3. Clean adhesive sticking on the parts.
4. Adjust the Position of the media guides
5. Adjust the position of the aligning roller.
For details, refer to page 5-21.
Jam code J-1714 or J-3105 is dis-
played
1. Check the tension setting.
2. Check the positions of the media and parts such as the roller guide.
3. Clean adhesive sticking on the parts.
4. Clear paper jams.
5. Change the tension setting.
For details, refer to the following page.
• For J-1714: page 5-26
• For J-3105: page 5-28
A Media-Break Error Occurs Roll Winder RW-201 has detected a media break.
Check whether the media is broken and whether media meandering or mis-
centering has occurred.
If the media has broken, tape up the break.
A Roll End Error Occurs Roll Winder RW-101 detected roll end.
Replace the media with a new one.
To Next Page
Loading...
