4-27
4.3 Weekly Cleaning
Setting a media to the main body
NOTICE
Turn on the main power switch and the sub power switch of the main body and turn on Roll Winder RW-101/Roll
Winder RW-201 beforehand.
To load the media on the machine, set the tension as shown below. For the setting procedure, refer to page 3-15.
- Position of tension roller 2: Top
- Aligning roller condition: Rotate
- Position of tension roller 4: Bottom
- Air level of paper feed loop fan: Auto
A Open the front door of Roll Winder RW-101 and move the lever to attach the rubber
roller.
B On the touch panel on Roll Winder RW-201, select [Menu] - [1. Machine state/2.
Machine setting] - [2] to set [Unwinder Online], [Rewinder Offline].
To Next Page
Loading...