28
RK-100S parameter guide
Arpeggio parameters
ARPEGGIATOR
Here you can adjust various arpeggio-related seings.
ON/OFF [O, On]
This turns the arpeggiator on/o.
TIMBRE ASSIGN [Timbre1, Timbre2, Timbre1+2]
Selects the timbre(s) that will be sounded by the arpeggiator.
TYPE [Up, Down, Alt1, Alt2, Random, Trigger]
Selects the arpeggio type.
Up: Notes will be played consecutively from low pitches to high.
Down: Notes will be played consecutively from high pitches to low.
ALT1: Up and Down will be alternated. (The highest and lowest notes will be
played once.)
ALT2: Up and Down will be alternated. (The highest and lowest notes will be
played twice, once on the way up, and once on the way down.)
Random: Notes will be played randomly.
Trigger: The notes you are holding down will be played simultaneously at the
tempo and “RESOLUTION” timing. The “OCTAVE RANGE” seing will be
ignored.
Note: If you are holding down more notes than the maximum polyphony of the
timbre, the lowest pitches you are holding down will be played, up to the
maximum polyphony.
OCTAVE RANGE [1, 2, 3, 4]
Species the range of octaves over which the arpeggio will be played.
RESOLUTION [1/32...1/1]
Species the resolution (spacing of the notes) relative to the tempo specied by
TAP buon.
1/32: The arpeggio will be played as 32nd notes at the specied tempo.
1/24: The arpeggio will be played as 16th note triplets at the specied tempo.
1/16: The arpeggio will be played as 16th notes at the specied tempo.
To Next Page
Loading...
Need help?
General
