Korg RK-100S Parameter Guide

47
Eect guide
See page 40 “LFO KeySync”
LFO Init Phase [000...180°]
Sets the starting location of the waveform
Note: This parameter will be displayed and can be set if “LFO KeySync” is On.
See page 41 “LFO Init Phase”
LFO Spread [–180...+180°]
Sets the phase dierence between the le and right channels
High Damp [000...100%]
Sets the damping amount in the high range
Trim [000...127]
Sets the input level
Modulation Delay
This is a stereo modulation delay.
Left
Right
Feedback
LFO Spread
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
Delay
Delay
LFO
Dry/Wet [Dry, 99:1...1:99, Wet]
Sets the balance between the eect and dry sounds
Delay Tempo Sync [O, On]
See page 44 “Delay Tempo Sync”
Time Ratio [Delay Tempo Sync O: 0.5...400.0%/
Delay Tempo Sync On: 12.5...400.0%]
See page 45 “Time Ratio”
L Delay Time [000...1400msec, 1/64... 1/1]
R Delay Time [000...1400msec, 1/64... 1/1]
See page 45 “L Delay Time, R Delay Time”
Feedback [000...127]
See page 45 “L Delay Time, R Delay Time”
Mod Depth [000...127]
Sets the depth of LFO modulation
LFO Frequency [0.01...100.0Hz]
Sets the LFO speed
Increasing this value will result in a faster frequency.
See page 40 “LFO Frequency”
LFO Spread [–180...180°]
Sets the phase dierence between the le and right channels

Korg RK-100S Specifications

General

Polyphony	8 voices
Arpeggiator	Yes
Type	Keytar
LFO	2 LFOs
Keyboard	37 keys (velocity sensitive)
Sound Engine	Analog modeling
Inputs	Audio input
Outputs	1 x 1/4" (audio)
Power Supply	6 x AA batteries or AC adapter
Dimensions	830 x 262 x 71 mm / 32.68 x 10.31 x 2.80 inches
Weight	3.4 kg / 7.50 lbs (excluding batteries)
Effects	Delay
Controllers	Ribbon controller
MIDI	Out
USB	Type B
Oscillators	2 oscillators