Korg RK-100S - Filter

39
Eect guide
Sensitivity=100
Sensitivity=40
Dry
Wet
Time
Level
Compressor - Sensitivity
Louder
Attack [000.1...500.0ms]
Sets the aack level
Output Level [000...127]
This parameter controls the output level.
Dry
Wet
Time
Level
Attack=1.0
Attack=400
Compressor - Attack
Filter
This is a stereo lter.
Left
Right
Dry / Wet
Response
Dry / Wet
Stereo In - Stereo Out
Filter
Filter
Control Source
LFO
Dry/Wet [Dry, 99:1...1:99, Wet]
Sets the balance between the eect and dry sounds
Filter Type [LPF24, LPF18, LPF12, HPF12, BPF12]
Selects the lter type
See page 18 “BALLANCE”
Cuto [000...127]
Sets the lter cuto frequency
See page 18 “CUTOFF”
Resonance [000...127]
Sets the lter resonance amount
See page 18 “RESONANCE”
Trim [000...127]
Sets the input level
Mod Source [LFO, Control]
Selects the modulation source that will control the cuto frequency.
If you set this to LFO, the LFO will modulate the cuto frequency.
If you set this to Control, the control source selected by “Control Source” will
control the cuto frequency.