Korg RK-100S - Timbre Eq; Master Effect 1, Master Effect 2

27
PROGRAM
TIMBRE EQ
Here you can adjust the equalizer seings. The equalizer is a shelving type.
LOW FREQ (Low EQ Frequency) [0020Hz...1000Hz]
Species the frequency of the low equalizer.
LOW GAIN (Low EQ Gain) [–15.0dB...+15.0dB]
Species the gain of the low equalizer.
Positive (+) values boost the region below the cuto frequency.
Negative (–) values cut the region below the cuto frequency.
HIGH FREQ (High EQ Frequency) [1.00 kHz...20.0 kHz]
Species the cuto frequency of the high equalizer.
HIGH GAIN (High EQ Gain) [–15.0dB...+15.0dB]
Species the gain of the high equalizer.
Positive (+) values boost the region above the cuto frequency.
Negative (–) values cut the region above the cuto frequency.
MASTER EFFECT 1, MASTER EFFECT 2
Here you can adjust seings for the master eects. You can choose from seventeen
dierent types.
FX.TYPE [Eect O...Grain Shifter]
This selects the eect type used by the master eect. For details on the available
eects, refer to page 37 “Eect guide”.
FX LONG RIBBON ( FILTER ) ASSIGN [Assign OFF ... ]
If an eect parameter is assigned to the “Long Ribbon (Filter)”, it can also be
controlled when the lter is controlled with the long ribbon controller.
FX LONG RIBBON ( FILTER ) POLARITY [Forward, Reverse]
The polarity direction assigned to the “FX LONG RIBBON (FILTER) ASSIGN”
can be switched.