Korg RK-100S - Ring Modulator

53
Eect guide
LFO Sync Note [8/1...1/64]
Sets the LFO frequency as a proportion of the tempo set by the TAP buon
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is On.
See page 40 “LFO Sync Note”
LFO Waveform [Saw, Square, Triangle, Sine, S&H]
Selects the LFO waveform
See page 40 “LFO Waveform”
LFO Shape [–63...+63]
See page 40 “LFO Shape”
LFO KeySync [O, On]
Species whether the LFO will be reset by note-on
See page 40 “LFO KeySync”
LFO Init Phase [000...180°]
Sets the starting location of the waveform
Note: This parameter will be displayed and can be set if “LFO KeySync” is On.
See page 41 “LFO Init Phase”
LFO Spread [–180...+180°]
Sets the LFO phase dierence between the le and right channels
Ring Modulator
This eect creates a metallic sound by applying the oscillators to the input signal.
Use the LFO or Dynamic Modulation to modulate the oscillator to create a radical
modulation. Matching the oscillator frequency with a note number will produce
a ring modulation eect in specic key ranges.
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
Pre LPF
Ring Modulator
Pre LPF
Ring Modulator
Note No.
OSC Mode
Fixed
Note (Key Follow)
Fixed Frequency
Pitch
Note Oset, Fine
Oscillator
LFO
Dry/Wet [Dry, 99:1...1:99, Wet]
Sets the balance between the eect and dry sounds
OSC Mode [Fixed, Note]
This parameter switches between specifying the oscillator frequency and using
a note number.
If this is set to Note, the oscillator frequency will track the note of the input signal.
Fixed Frequency [0Hz...12.0kHz]
This parameter sets the oscillator frequency when “OSC Mode” is set to Fixed.
If this parameter is assigned to the “Long Ribbon (Filter)”, it can be switched
to “Note Oset” if the “OSC MODE” is set to Note.
Note Oset [–48...+48]
Sets the pitch dierence from the original note in semitone steps when the “OSC
Mode” is set to Note