50
RK-100S parameter guide
See page 40 “LFO Tempo Sync”
LFO Frequency [0.01...100.0Hz]
Sets the LFO speed
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is O.
See page 40 “LFO Frequency”
LFO Sync Note [8/1...1/64]
Sets the LFO frequency as a proportion of the tempo set by the TAP buon
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is On.
See page 40 “LFO Sync Note”
LFO Waveform [Saw, Square, Triangle, Sine, S&H]
Selects LFO Waveform
See page 40 “LFO Waveform”
LFO Shape [–63...+63]
See page 40 “LFO Shape”
LFO KeySync [O, On]
Species whether the LFO will be reset by note-on
See page 40 “LFO KeySync”
LFO Init Phase [000...180°]
Sets the starting location of the waveform
Note: This parameter will be displayed and can be set if “LFO KeySync” is On.
See page 41 “LFO Init Phase”
LFO Spread [–180...+180°]
Sets the LFO phase dierence between the le and right channels
High Damp [000...100%]
Sets the feedback damping amount in the high range
Vibrato
This eect causes the pitch of the input signal to shimmer
Vibrato
Vibrato
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
LFO
LFO Shape
LFO Spread
Dry/Wet [Dry, 99:1...1:99, Wet]
Sets the balance between the eect and dry sounds
Mod Depth [000...127]
Sets the depth of LFO modulation
LFO Tempo Sync [O, On]
Species whether the LFO cycle will be synchronized with the tempo specied
by the TAP buon or MIDI clock
See page 40 “LFO Tempo Sync”
LFO Frequency [0.01...100.0Hz]
Sets the LFO speed
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is O.
See page 40 “LFO Frequency”
LFO Sync Note [8/1...1/64]
Sets the LFO frequency as a proportion of the tempo set by the TAP buon
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is On.
See page 40 “LFO Sync Note”
To Next Page
Loading...
Need help?
General
