Korg RK-100S Parameter Guide

54
RK-100S parameter guide
Note Fine [–100...+100]
Sets the pitch dierence from the original note in cent steps when the “OSC
Mode” is set to Note
Note: By seing “Note Oset” and “Note Fine” so that the oscillator frequency
will track the note that is input, you can produce a ring modulator eect
with a correct scale.
OSC Waveform [Saw, Triangle, Sine]
Selects the ocsillator waveform
LFO Intensity [–63...+63]
Sets the depth of LFO modulation
LFO Tempo Sync [O, On]
Species whether the LFO cycle will be synchronized with the tempo specied
by the TAP buon or the MIDI clock
See page 40 “LFO Tempo Sync”
LFO Frequency [0.01...100.0Hz]
Sets the LFO speed
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is O.
See page 40 “LFO Frequency”
LFO Sync Note [8/1...1/64]
Sets the LFO frequency as a proportion of the tempo set by the TAP buon
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is On.
See page 40 “LFO Sync Note”
LFO Waveform [Saw, Square, Triangle, Sine, S&H]
Selects the LFO waveform
See page 40 “LFO Waveform”
LFO Shape [–63...+63]
See page 40 “LFO Shape”
LFO KeySync [O, On]
Species whether the LFO will be reset by note-on
See page 40 “LFO KeySync”
LFO Init Phase [000...180°]
Sets the starting location of the waveform
Note: This parameter will be displayed and can be set if “LFO KeySync” is On.
See page 41 “LFO Init Phase”
Pre LPF [000...127]
This parameter enables you to set the damping amount of the high range sound
input to the ring modulator. If the input sound contains many harmonics, the
eect may sound dirty. In this case, cut a certain amount of high range.
Grain Shifter
This eect samples extremely brief fragments of the sound at a specied interval,
and plays them as a loop. This is eective when used on external input sounds
that are constantly changing.
+
Left
Right
Sample Cycle
Dry / Wet
Dry / Wet
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
LFO
Grain Shifter
Dry/Wet [Dry, 99:1...1:99, Wet]
Sets the balance between the eect and dry sounds

Korg RK-100S Specifications

General

Polyphony	8 voices
Arpeggiator	Yes
Type	Keytar
LFO	2 LFOs
Keyboard	37 keys (velocity sensitive)
Sound Engine	Analog modeling
Inputs	Audio input
Outputs	1 x 1/4" (audio)
Power Supply	6 x AA batteries or AC adapter
Dimensions	830 x 262 x 71 mm / 32.68 x 10.31 x 2.80 inches
Weight	3.4 kg / 7.50 lbs (excluding batteries)
Effects	Delay
Controllers	Ribbon controller
MIDI	Out
USB	Type B
Oscillators	2 oscillators