Name: Korg RK-100S
Brand: Korg
Rating: 5 (1 reviews)

To Next Page

To Previous Page

RK-100S parameter guide

7. When Wave: Saw, Pulse, Triangle, Sine and OSC1 Mod: Unison

CONTROL1: Detune (Unison Detune) [000...127]

This parameter adjusts the dierence in pitch between the ve unison oscillators.

Higher values will broaden the pitch dierence between the oscillators, producing

a richer sound.

CONTROL2: Phase (Oscillator Phase) [000...127]

Species the phase of each oscillator at note-on. This will aect the tone of the

aack. A seing of 127 will change the pitch and volume.

000 (0º) 063 (90º) 127 (180º)

Saw

Pulse

riangle

Sine

8. When Wave: aw, Pulse, Triangle, Sine and OSC1 Mod: VPM

CONTROL1: Mod Depth (VPM Depth) [000...127]

Adjusts the depth of VPM

CONTROL2: Harmonics (Mod Harmonics) [001...032]

Species the frequency of the VPM modulator as a harmonic multiple of oscillator 1

OSCILLATOR2

Here you can adjust the seings for oscillator 2. By using this in conjunction with

oscillator 1 you can obtain a variety of sounds. For example by adjusting OSC2

SEMITONE and OSC2 TUNE, you can make one oscillator act as an overtone

of the other oscillator. Alternatively, you can create a musical interval by seing

each oscillator to a dierent pitch, or create a detuned eect by seing the two

oscillators to slightly dierent pitches. You can also apply ring modulation or

oscillator sync to generate complex overtones (this is done using the OSC2 “OSC

MOD” parameter).

WAVE [Saw, Pulse, Triangle, Sine]

Selects a waveform for oscillator 2.

Saw: A sawtooth wave.

PULSE: A square wave.

Triangle: A triangle wave.

Sine: A sine wave.

If you do not hear the sound of oscillator 2, go to the MIXER and raise “OSC2”. If

you want to hear only the sound of oscillator 2, lower the “OSC 1” on the MIXER.

Other manuals for Korg RK-100S

Questions and Answers:

Need help?

Do you have a question about the Korg RK-100S and is the answer not in the manual?

General