52
RK-100S parameter guide
See page 40 “LFO Tempo Sync”
LFO Frequency [0.01...100.0Hz]
Sets the LFO speed
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is O.
See page 40 “LFO Frequency”
LFO Sync Note [8/1...1/64]
Sets the LFO frequency as a proportion of the tempo set by the TAP buon
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is On.
See page 40 “LFO Sync Note”
LFO Waveform [Saw, Square, Triangle, Sine, S&H]
Selects the LFO waveform
See page 40 “LFO Waveform”
LFO Shape [–63...+63]
See page 40 “LFO Shape”
LFO KeySync [O, On]
Species whether the LFO will be reset by note-on
See page 40 “LFO KeySync”
LFO Init Phase [000...180°]
Sets the starting location of the waveform
Note: This parameter will be displayed and can be set if “LFO KeySync” is On.
See page 41 “LFO Init Phase”
LFO Spread [–180...+180°]
Sets the LFO phase dierence between the le and right channels
High Damp [000...100%]
Sets the feedback damping amount in the high range
Tremolo
This eect modulates the volume level of the input signal. The eect is stereo,
and oseing the LFO of the le and right phases from each other produces a
tremolo eect between le and right.
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
LFO Spread
LFO
LFO Shape
Tremolo
Tremolo
Dry/Wet [Dry, 99:1...1:99, Wet]
Sets the balance between the eect and dry sounds
Mod Depth [000...127]
Sets the depth of LFO modulation
LFO Tempo Sync [O, On]
Species whether the LFO cycle will be synchronized with the tempo specied
by the TAP buon or MIDI clock
See page 40 “LFO Tempo Sync”
LFO Frequency) [0.01...100.0Hz]
Sets the LFO speed
Note:
This parameter will be displayed and can be set if “LFO Tempo Sync” is O.
See page 40 “LFO Frequency”
To Next Page
Loading...
Need help?
General
