Korg RK-100S Parameter Guide

48
RK-100S parameter guide
Tape Echo
This eect simulates a tape echo unit. The distortion and tonal change typical of
magnetic tape are also reproduced.
Wow Flutter
Tap2 Level
+
Tape
Saturation
Left
Right
Dry / Wet
Trim
Tap1 Level
Dry / Wet
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Feedback
High / Low Damp
Pre Tone
Delay
Spread
Dry/Wet [Dry, 99:1...1:99, Wet]
Sets the balance between the eect and dry sounds
Delay Tempo Sync [O, On]
See page 44 “Delay Tempo Sync”
Time Ratio [Delay Tempo Sync O: 0.5...400.0%/
Delay Tempo Sync On: 12.5...400.0%]
See page 45 “Time Ratio”
Tap1 Delay Time [0000...1400ms, 1/64... 1/1]
Tap2 Delay Time [0000...1400ms, 1/64... 1/1]
Sets the delay times for Tap1 and Tap2
See page 45 “L Delay Time, C Delay Time, R Delay Time”
Tap1 Level [000...127]
Tap2 Level [000...127]
Sets the Tap1 output level and Tap2 output level
Feedback [000...127]
Sets the Tap1 feedback amount
High Damp [000...100%]
Sets the damping amount in the high range
Low Damp [000...100%]
Sets the damping amount in the low range
Trim [000...127]
Sets the input level
Saturation [000...127]
Sets the distortion amount
WOW Flutter Frequency [0.01...100.0Hz]
Sets the frequency where pitch variation will occur in Hz steps
WOW Flutter Depth [000...127]
Sets the depth of pitch variation
Pre Tone [000...127]
Sets the tone of the input
Spread [000...127]
Sets the width of the stereo image of the eect sound
See page 45 “Spread”

Korg RK-100S Specifications

General

Polyphony	8 voices
Arpeggiator	Yes
Type	Keytar
LFO	2 LFOs
Keyboard	37 keys (velocity sensitive)
Sound Engine	Analog modeling
Inputs	Audio input
Outputs	1 x 1/4" (audio)
Power Supply	6 x AA batteries or AC adapter
Dimensions	830 x 262 x 71 mm / 32.68 x 10.31 x 2.80 inches
Weight	3.4 kg / 7.50 lbs (excluding batteries)
Effects	Delay
Controllers	Ribbon controller
MIDI	Out
USB	Type B
Oscillators	2 oscillators