31
PROGRAM
FORMANT SHIFT [–2...+2]
Shis the cuto frequencies of each of the carrier’s band pass lters. This will
signicantly change the character of the vocoder output.
FC OFFSET [–63...+63]
This continuously shis the cuto frequency of each band-pass lter (Synthesis
lter) of the carrier.
FORMANT SHIFT and FC OFFSET
When “FORMANT SHIFT”=0 and “FC OFFSET”=0, the response of the carrier
lters will match the cuto frequency of the modulator lters. The lter response
is shied upward or downward in two discrete steps by the “FORMANT SHIFT.”
This can be adjusted upward or downward a total of another two steps by
using “FC OFFSET,” giving you a total of four steps of adjustment upward or
downward.
Cuto (the range in which BPF 8 will change)
0 +63-63
BPFBPFBPFBPF BPFBPF
BPFBPFBPFBPF BPFBPF
897
897
Frequency
Frequency
Formant Shift:+2
Cuto (the range in which BPF 8 will change)
0
+63
-63
RESONANCE [000...127]
This species the amount of resonance for each of the carrier’s sixteen band-pass
lters (the synthesis lter). Higher seings will boost the sound in the region of
the cuto frequency.
FC MOD SOURCE (Fc Modulation Source)
[FILTER EG...MIDI Control 3]
Selects the modulation source that will be applied to the carrier band-pass lter
“FC OFFSET.”
Note: The sources you can select are the same as the modulation sources for a
virtual patch (see page 25“SOURCE”). However, Filter EG, Amp EG,
Assignable EG, LFO1–2, Velocity, and Keyboard Track will be the sources
for timbre 1. Also, you won’t be able to select the Long Ribbon (Filter).
E.F.SENS (Envelope Follower Sens) [000...126, Hold]
Species the sensitivity of the modulator’s Envelope Followers.
Lower seings of this value will allow the aacks of the input signal to be detected
more rapidly.
Higher values will produce slower change, creating a sound with a slow aack
and a long release.
If you set this to Hold, the character of the signal that is being input at that moment
will be held (Formant Freeze). Subsequently, the sound will retain that character
regardless of whether there is any input.
If you set this to Hold when there is no input signal present, there will be no
output even if an audio signal is subsequently input.
Note:
If you write the program with this value set to Hold, the program will
memorize the response of the signal that was being held.
FC MOD INT [–63...+63]
Species the depth of the modulation that is applied to the carrier band-pass lter
(Synthesis lter) “FC OFFSET.”
To Next Page
Loading...
Need help?
General
