60
RK-100S parameter guide
applied over the full pitch range specied by “VIBRATO INTENSITY” If the
value of the received message is 0, no vibrato will apply.
The modulation depth is transmied on the global MIDI channel when the short
ribbon controller is used while the SHORT RIBBON buon is lit up in red.
• Volume (CC#07) [Bn, 07, vv]
If you assign the control change Volume (CC#07) to “AMP LEVEL” in the CC#
MAP, incoming Volume messages will control the volume.
• Panpot (CC#10) [Bn, 0A, vv]
If you assign the control change Panpot (CC#10) to “PANPOT” in the CC# MAP,
incoming Panpot messages will control the stereo position of the sound.
• Expression (CC#11) [Bn, 0B, vv]
When expression messages are received, the volume of a timbre will be controlled.
The volume will be at maximum if the maximum value (127) is received, and at
zero if the minimum value (0) is received.
• Damper pedal (CC#64) [Bn, 40, vv]
Incoming damper pedal messages will turn the timbre’s damper eect (Hold)
on/o (0: O, 127: On).
• Portamento (CC#65) [Bn, 41, vv]
When portamento messages are received, the portamento eect of a timbre will
be switched on/o. If the portamento time is set to 0, there will be no portamento
eect. (0: o, 7F: on).
• All note o (CC#123) [Bn, 7B, 00] (value is 00)
When an All Note O message is received, all currently-sounding notes of that
channel will be turned o. Some sound may linger due to the envelope seings.
• All sound o (CC#120) [Bn, 78, 00] (value is 00)
When an All Sound O message is received, all notes currently sounding on that
channel will be silenced. While All Note O allows the decay of a note to continue,
the All Sound O will silence the sound immediately. However, this message is
intended for use in emergencies, and is not for use during a performance.
• Reset all controllers (CC#121) [Bn, 79, 00] (value is 00)
When a Reset All Controllers message is received, all controller values currently
running on that channel will be reset. Some parameters assigned using Virtual
Patches will not be reset.
Using a control change as a virtual patch modulation source
By selecting CC#cc (cc=00–95, 102–119) as the “SOURCE” for MIDI Control 1,
MIDI Control 2, or MIDI Control 3 in the VIRTUAL PATCH, you can use control
changes as a modulation source for a virtual patch, vocoder “FC MOD SOURCE,”
or eect parameter. The actual value of 0–127 will be used without change as the
modulation source.
Assigning a control change to a ribbon controller or button
In the CC # MAP, you can assign the control changes CC#00–CC#95 and CC#102–
CC#119 to principal parameters that correspond to ribbon controllers or buons.
When you use an assigned ribbon controller or buon, the corresponding control
change will be transmied. When that control change is received from an external
device, the result will be the same as if that ribbon controller or buon had been
used with the corresponding value (see page 36 “CC # MAP”).
To Next Page
Loading...
Need help?
General
