Krone 1022623 - Menu 4 Tying Start Delay (Chamber Film Wrapping)

15 Terminal menus
15.12 Menu 4 “Tying start delay” (chamber film wrapping)
136
Comprima F 155
Original Operating Instructions 150001049_01_en
n
1,0
0,0
0.0
s
4
EQG003-003
ü For The menu level is active, refer to page130.
ü For the “Net and chamber film wrapping” version: Net wrapping is selected in menu 8 “Type
of tying”, refer to page138.
 To open the menu, press
.
Æ The display shows menu “Tying start delay”.
Adjusting the tying start delay
 Increase or decrease the value, refer to page131.
 To save the value, press
.
15.12 Menu 4 “Tying start delay” (chamber film wrapping)
Tying start delay is used to set the period of time which is required between completion of round
bale in the bale chamber and triggering the tying cycle. The tying start delay is set in seconds.
Setting range: 0.0–1.0s
n
1,0
0,0
0.0
s
4
EQG003-004
ü For The menu level is active, refer to page130.
ü Chamber film wrapping is selected in menu 8 “Type of tying”, refer to page138.
 To open the menu, press
.
Æ The display shows menu “Tying start delay”.