Krone 1022623 - Mounting Safety Chain

7 Commissioning
7.15 Mounting safety chain
68
Comprima F 155
Original Operating Instructions 150001049_01_en
The road travel lighting is connected by means of the enclosed 7-pin lighting cable(2).
ü The machine is shut down and safeguarded, refer to page27.
 Connect the 7-pin plug of the lighting cable(2) to the 7-pin socket(1) of the machine.
 Connect the 7-pin plug of the lighting cable(2) to the 7-pin socket(3) of the tractor.
 Lay the lighting cable(2) so that it does not touch the tractor wheels.
7.15 Mounting safety chain
WARNING
Risk of accident due to a incorrectly dimensioned safety chain
When using a incorrectly dimensioned safety chain, the safety chain may tear if the machine
loosens unintentionally. This may result in serious accidents.
 Always use safety chain with a minimum tensile strength of 178 kN (40,000 lbf).
INFORMATION
The country-specific regulations for using the safety chain during transportation of the
machine must be observed.
The safety chain serves as an additional safety precaution for trailed devices in case these
come loose from the hitch during transport. Attach the safety chain with the respective mounting
parts to the hitching device holder of the tractor or to another specified coupling point. The
safety chain should have enough play when driving around curves.
ü The machine is shut down and safeguarded, refer to page27.
RP000-104
 Mount the safety chain (1) on the machine.
I
II
DV000-016
 Install the safety chain(1) at a suitable position (for example: [I] or [II]) on the tractor.