Krone 1022623 - Mounting Hose and Cable Support; Preparing the Brake Disc of the Wrapping Material Brake; Checking;Adapting the Tyre Pressure

6 Initial operation
6.2 Mounting hose and cable support
46
Comprima F 155
Original Operating Instructions 150001049_01_en
5 Small parts 12 Universal shaft bracket
6 7-pole connection cable for road travel
lighting
13 Actuating lever for the reversing device
7 Hose and cable support
6.2 Mounting hose and cable support
3
4
1
2
RPG000-010
ü The machine is shut down and safeguarded, refer to page27.
 Remove the hose and cable support (1) from the storage compartment.
 Insert the hose and cable support (1) into the oblong holes (3) on the right-hand and left-
hand side of the drawbar.
 Mount the hose and cable support (1) with the terminals (2) from the inside and with the nuts
(4) from the outside.
Æ The hoses and cables can be guided through the eye on the hose and cable support (1)
towards the tractor.
6.3 Preparing the brake disc of the wrapping material brake
RPG000-011
 Remove the duct tape (1) provided as corrosion protection from the surface of the brake
disc (2) and discard.
6.4 Checking/adapting the tyre pressure
Before the initial operation, check and adjust the tyre pressure. A label at the PTO shaft end
draws the attention to this important test: