Krone 1022623 - Danger Zones

2 Safety
2.4 Basic safety instructions
18
Comprima F 155
Original Operating Instructions 150001049_01_en
Technical limit values
If the technical limit values of the machine are not observed, the machine may be damaged. As
a result, accidents may occur and people may be seriously or fatally injured. With regard to
safety, it is especially important to observe the following technical limit values:
• maximum permitted operating pressure of the hydraulics
• maximum permitted drive speed
• maximum permitted total weight
• maximum permitted axle load/axle loads
• maximum permitted drawbar load
• maximum permitted axle loads of the tractor
• maximum permitted transport height and width
• maximum permitted speed
 Comply with limit values, refer to page42.
2.4.10 Danger zones
If the machine is switched on, its surrounding can present a danger zone.
Avoid entering the danger zone of the machine by observing the minimum safety distance.
If the safety distance is not observed, people may be seriously injured or killed.
 Do not switch on the drives and engine if the minimum safety distance has not been
observed.
 If people fail to observe the minimum safety distance, switch off the drives.
 Switch the machine off in shunting and field mode.
The safety distance is:
For machine in shunting operation and field mode
In front of the machine 3 m
Behind the machine 5 m
Laterally to the machine 3 m
For machine switched on without driving motion
In front of the machine 3 m
Behind the machine 5 m
Laterally to the machine 3 m
The safety distances specified here are minimum distances in terms of intended use. If
necessary, these safety distances must be increased according to the operating and ambient
conditions.
 Before working in front of and behind the tractor and in the danger zone of the machine:
Shut down and secure the machine, refer to page27. This also applies to brief inspection
work.
 Consider the information in all relevant operating instructions:
• The operating instructions of the tractor
• The operating instructions of the machine
• The operating instructions of the universal shaft