EasyManua.ls Logo

Krone 1022623 - Jobs on the Machine; Operational Safety: Technically Sound Condition

Krone 1022623
264 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety 2
Basic safety instructions 2.4
Comprima F 155
Original Operating Instructions 150001049_01_en 17
2.4.8 Jobs on the machine
Passengers
Passengers may be seriously injured by the machine or fall off the machine and run over.
Ejected objects may strike and injure passengers.
Never carry passengers on the machine.
2.4.9 Operational safety: Technically sound condition
Operation is only allowed after proper start-up
The operational safety of the machine is not ensured when it is not started up properly
according to these operating instructions. Thus accidents may be caused and persons may be
seriously injured and killed.
Only use the machine after proper start-up, refer to page53.
Technically sound state of the machine
Improper maintenance and setting could influence the operational safety of the machine and
cause accidents. Thus there is a risk of serious injuries or death.
All maintenance and setting work must be performed according to the chapters
“Maintenance and Setting”.
Before performing any maintenance and setting work, shut down and safeguard the
machine, refer to page27.
Danger resulting from damage to the machine
Damage to the machine may impair the operational safety of the machine and cause accidents.
As a result, people may be seriously injured or killed. The following parts of the machine are
particularly important for safety:
Brakes
Steering
Safety Devices
Connecting devices
Lighting
Hydraulics
Tyres
Universal shaft
If there are doubts about the operational safety of the machine, for example due to an
unexpected change to the operational behaviour, visible damage or leaking consumables:
Shut down and safeguard the machine, refer to page27.
Immediately eliminate potential causes of damage, for example heavy soiling, or tighten
slack screws.
Determine the cause of damage according to these operating instructions and repair the
damage, if possible, refer to page211.
In case of damage which may affect operational safety and cannot be repaired according to
these operating instructions: Have damage repaired by a qualified service centre.

Table of Contents

Related product manuals