Krone 1022623 - Malfunctions on the Chain Lubrication Unit

Malfunction, cause and remedy 19
Malfunctions on the chain lubrication unit 19.4
Comprima F 155
Original Operating Instructions 150001049_01_en 215
19.4 Malfunctions on the chain lubrication unit
Malfunction: The oil consumption is too low.
Possible cause Remedy
The nozzles of the central
chain lubrication are soiled so
that the oil pump pressure is
too low.
 Clean the dosing units of the central chain lubrication
system, refer to page207.
 Clean the oil pump, refer to page206.
The pressure is too low, as
the oil pump is not pressed in
for the complete stroke.
 Increase the oil quantity, refer to page206.
 Have the oil pump dismounted and cleaned or replaced by a
KRONE service partner.
The oil is too thick.
 Use recommended oil, refer to page43.
The central chain lubrication
system is contaminated.
 Clean the entire central chain lubrication system.
Malfunction: The oil consumption is too high.
Possible cause Remedy
The main tube is torn.
 Have the main tube repaired or replaced changed by a
KRONE service partner.
The oil is too thin.
 Use recommended oil, refer to page43.
Malfunction: The machine is dry.
Possible cause Remedy
There is no pressure. The oil
pump is not functioning.
 Have the oil pump dismounted and cleaned or replaced by a
KRONE service partner.
There is no pressure. The
main tube is torn.
 Have the main tube repaired or replaced changed by a
KRONE service partner.
There is no pressure. The
system has no oil.
 Vent the chain lubrication unit, refer to page206.
The system is blocked, as the
main tube is jammed.
 Have the main tube repaired or replaced changed by a
KRONE service partner.
Malfunction: The oil pump is not pressed for the complete stroke.
Possible cause Remedy
The dosing units are blocked.
 Cleaning the dosing units, refer to page207.
The oil is too thick.
 Use recommended oil, refer to page43.