Krone 1022623 - Maintenance - Every 50 Hours; Maintenance - Every 500 Hours; Maintenance - Every 2 Years; Lubrication Chart

Maintenance 18
Lubrication chart 18.2
Comprima F 155
Original Operating Instructions 150001049_01_en 181
18.1.7 Maintenance – every 50 hours
Components
Tighten screws/nuts on the machine refer to page185
Tighten the screw connections on the drawbar refer to page194
Retightening wheel nuts refer to page189
Check tyre pressure refer to page189
Drain condensation water out of the com-
pressed air tanks of the compressed air brake
refer to page209
18.1.8 Maintenance – every 500 hours
Changing oil
Main gearbox refer to page190
18.1.9 Maintenance – Every 2 years
Components
Have compressed-air tanks checked by
KRONE service partner
Have pneumatic brake cylinders serviced by
KRONE service partner
18.2 Lubrication chart
NOTICE
Damage to bearing points
When using lubricating greases not approved and when mixing different lubricating greases,
the lubricated parts may be damaged.
 Only use approved lubricating greases, refer to page44.
 Do not use graphite-containing lubricating greases.
 Do not mix different lubricating greases.
NOTICE
Environmental damage caused by consumables
If consumables are not stored and disposed of properly, they may escape into the
environment. As a result, the environment will be damaged, even by small quantities.
 Store the consumables in suitable containers according to the statutory provisions.
 Dispose of used consumables according to statutory provisions.
The information on maintenance intervals is based on average load of the machine. In case of
an increased load and under extreme working conditions, the time periods must be reduced.
The types of lubrication are marked by means of icons in the lubrication chart, refer to table.