Krone 1022623 - Fitting Wheel Chocks

Operation 8
Fitting wheel chocks 8.8
Comprima F 155
Original Operating Instructions 150001049_01_en 77
The safety cable(1) applies the parking brake(3) if the machine breaks away from the tractor
while it is driving.
 To attach the safety cable(1) to the machine, attach the safety cable(1) to the parking
brake(3). To do this, pull the safety cable(1) through the smaller loop of the safety cable(1)
and through the ring(2).
 To attach the safety cable(1) to the tractor, attach the other end of the safety cable(1) to a
suitable point at the back of the tractor.
 Ensure that the safety cable(1) cannot slip or become detached.
8.8 Fitting wheel chocks
1
2
RPG000-012
The wheel chocks(1) secure the machine against rolling away. 2wheel chocks are affixed to
the machine.
For "Parking brake" version: In order to prevent the machine from rolling away, use the
parking brake in addition to the wheel chocks(1), refer to page76.
ü The machine is shut down and safeguarded, refer to page27.
 To dismount the wheel chocks (1) from the machine, press the supports (2) down, pull the
wheel chocks (1) upwards, and remove them.
1 1
RPG000-180
 Park the machine on level and firm ground.
 Place the wheel chocks (1) so close before and behind the same wheel that the machine
cannot roll off.