Krone 1022623 - Setting the Brake Force Release When Feeding Wrapping Material

17 Settings
17.6 Setting the brake force release when feeding wrapping material
170
Comprima F 155
Original Operating Instructions 150001049_01_en
17.6 Setting the brake force release when feeding wrapping material
1
3
2
4
RP000-019
Particularly when the chamber film wrapping is set, there is a risk that the film will overturn on
the film roll instead of being fed to the round bale. If this happens, the brake force release
should be adjusted for the feed process.
When the wrapping material is guided to the round bale, the brake force should be reduced so
that the wrapping material can be pulled more easily off the round bale.
This brake force release during the feed process can be set on the spring(3) on the right side of
the machine behind the side hood.
The more the spring(3) is tensioned, the greater the brake force release during the feed
process.
ü The actuator for wrapping process is in the feed position, refer to page140.
ü The machine is shut down and safeguarded, refer to page27.
 Check that the disc(2) is located above the spring(3) at the level of the central notch(4).
 To change the tension of the spring(3), loosen or tighten the nut(1).
Notches(4) Spring tension(3) Wrapping material for the feed pro-
cess
top low The wrapping material can be pulled
with difficulty.
central medium The wrapping material can be pulled
with medium strength. KRONE re-
commends this setting as an op-
timum brake force release during the
feeding of the wrapping material.
bottom strong The wrapping material can be pulled
easily.