Krone 1022623 - Crop Blockage under Feed Rotor; Crop Blockage in the Baling Element; Operating the Reversing Device with Crop Blockages

Operation 8
Operating the reversing device with crop blockages 8.19
Comprima F 155
Original Operating Instructions 150001049_01_en 93
8.18.3 Crop blockage under feed rotor
To remove the accumulated crops from under the feed rotor, proceed as follows:
 Switch off the PTO shaft.
 Reverse.
 Ensure that the tractor is in straight alignment with the machine.
 For version with "Manual reversing device": Manually turn back the feed rotor with the
actuating lever, refer to page93
 For version with "Drop floor of feed rotor": Lower the feed rotor floor, refer to page84.
 Switch on the PTO shaft and test at idling speed whether the crop blockage is being
removed.
If this does not remove the crop blockage:
 Shut down and safeguard the machine, refer to page27.
CAUTION!Risk of injury due to sharp parts! Always wear appropriate protective gloves
when removing crop blockages.
 Manually remove the accumulated crops.
8.18.4 Crop blockage in the baling element
 Switch on the PTO shaft.
 Open the tailgate.
 Shut down and safeguard the machine, refer to page27.
 Close the stop cock, refer to page75.
CAUTION!Risk of injury due to sharp parts! Always wear appropriate protective gloves
when removing crop blockages.
 Manually remove the accumulated crops from the baling element.
 Open the stop cock, refer to page75.
 Switch on the tractor engine and the PTO shaft.
 Close the tailgate.
 Resume baling.
8.19 Operating the reversing device with crop blockages
In the case of crop blockages the reversing device can be used to manually turn back the feed
rotor. This allows the crop blockage to be removed more easily.