Krone 1022623 - Checking and Setting End Position for Chamber Film Wrapping

17 Settings
17.3 Checking and setting the position of the feed rocker arm
166
Comprima F 155
Original Operating Instructions 150001049_01_en
17.3.2 Checking and setting end position for chamber film wrapping
1
2
3
RP000-028
The end position has been optimally set, with chamber film wrapping activated, when the feed
rocker arm(1) is in the end position on the insulation of the pressure shaft(2). As a result, the
film is clamped and held in position.
 Open menu 10 "Manual operation" on the terminal, refer to page140.
 Move the feed rocker arm(1) to the saved end position.
 Switch off the tractor, remove the ignition key and take it with you.
 Check whether the conical roller(3) is positioned on the insulation of the pressure shaft(2)
and whether the film jams between the insulation of the pressing shaft(2) and the conical
roller(3).
If the film is not jammed between the insulation of the pressure shaft(2) and the conical
roller(3):
 Start the tractor.
 Move the feed rocker arm in the direction of the end position until the conical roller(3) is
positioned on the insulation of the pressure shaft(2) and the film is clamped between the
insulation and pressure shaft.
 Save the new position.