Krone Big Pack 890 HS - Menu 1-1 Correction Value Bale Length

KRONE ISOBUS-Terminal CCI 100
106
Pos: 24.55 /BA/Inf o-Center/CC-ISOBUS- Terminal/CCI-Bi G Pack/Hauptmenüs/Haupt menü 1 Einstellungen/ Menü 1-1 „Korrekturwer t Ballenlänge“ HS Baureihe @ 63\mod_1300084468778_ 78.doc @ 577611
7.10.1 Menu 1-1 „Correction value bale length“
CC000029
1-1
Fig. 65
Because of different properties of materials (for example straw, silage) the actual bale length
may differ from the pre-set target value. The correction value can be used to correct this
deviation.
Factory setting: 100%
Calling the menu
Main menu 1 “Settings” is displayed.
• You can select menu 1-1
with the function key or . The symbol is shown in
reverse colors
• Press function key
The display shows menu 1-1 "Correction value for bale length".
The bar display and the percentage value indicate the set correction value. The symbol
in
the upper line indicates that the displayed value is saved.
Setting and saving the correction value
If the bale is too long, reduce the correction value. If the bale is too short, increase the
correction value.
• Set the desired correction value with the function key
or . The symbol in the top
line goes out
• Press the function key
. The set correction value is saved and the symbol
appears in the upper line
• By pressing the function key
the value of the factory setting appears (press function
key
, the value of the factory setting will be saved, the symbol appears in the
upper line)
• Pressing the function key
closes the called up menu
• Pressing the function key
and holding it down brings up the basic screen
Pos: 24.56 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165