Operation
162
Pos: 30.15.21 /BA/Ei nstellungen/Schnei dwerk/Verstopfung en entfernen Big Pack @ 20\ mod_1238654439288_78. doc @ 224033
9.6 Removing blockages
• Wait until all moving components stop
• Apply the flywheel brake
• Lower the cutting system with the tractor hydraulics (with the Comfort electronics system:
Activate the tractor hydraulics and hold down “Lower blade bar” on the control unit display
or on the machine buttons until the cutting system is lowered all the way down)
CAUTION! - Sharp parts
Effect: severe risk of injury
Always wear protective gloves when removing blockages.
Note
Due to too low ground clearance, the cutting system must immediately be lifted after removal of
the blockage, otherwise the cutting system inlet tray will be damaged. Should the cutting
system inlet tray be extremely dirty, clean it before lifting.
• Remove blockage
• Raise the cutting system with the tractor hydraulics (with the comfort electronics system:
Activate the tractor hydraulics and hold down “Lift blade bar” on the control unit display or
on the machine buttons until the cutting system is lifted all the way).
Pos: 30.15.22 /BA/E instellungen/Schnei dwerk/Bei Ausführun g Medium – Elektronik mus s der Absperrhahn (1) gesc hlossen sein Bild @ 62\ mod_1299600536457_78. doc @ 573544
BPHS0014
Fig.96
Pos: 30.15.23 /BA/E instellungen/Schnei dwerk/Bei Ausführun g Medium – Elektronik mus s der Absperrhahn (1) gesc hlossen sein @ 62\mod_129 9599111686_78.doc @ 573490
Note
With the Medium electronics version the shut-off valve (1) must be closed so that the cutting
system can be lowered or raised via the tractor's hydraulic system.
The shut-off valve is to be found on the rear left-hand side of the machine, near the parking
brake.
Pos: 30.16 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
