Krone Big Pack 890 HS - Load-Sensing Connection

Start-up
65
Pos: 18.36.1 /Überschr iften/Überschr iften 2/K-O/Load-Sensi ng-Anschluss @ 1\ mod_1201241225401_78. doc @ 51955
5.5 Load-sensing connection
Pos: 18.36.2 /BA/W artung/Load-Sensing/ Großpackenpresse/Bi ld Load-Sensing Ansc hluss HS Baureihe @ 64\mod_13 00278753983_78.d oc @ 582789
Fig.27
Pos: 18.36.3 /BA/W artung/Load-Sensing/ Großpackenpresse/L oad-Sensing-Anschl uss BigPack @ 24\mod_12416 04498659_78.doc @ 24 6628
The Comfort hydraulic system is load-sensing-capable.
The oil supply comes through the Power-Beyond system of the tractor hydraulics for use of the
load-sensing system (further information can be obtained from the operating instructions
provided by the manufacturer of the tractor).
Pos: 18.36.4 /BA/W artung/Load-Sensing/ Großpackenpresse/An passen des Hydrauliksy stems BiG PAck @ 17\mod_12 36336508823_78.d oc @ 205078
The comfort hydraulic system of the machine must be adjusted on the tractor. It is designed for
continuous circulation. The adjustment is made by adjusting the hydraulic system screw on the
control valve block of the machine. The control valve block is located at the front left under the
side hood next to the electronics box.
Note
The adjustment depends on the hydraulic system of the tractor and must be made while there
is no pressure in the machine!
Pos: 18.36.5 /BA/W artung/Load-Sensing/Sy stemschreube (1) ganz herausdrehen @ 63\mod_1 299739012796_78.doc @ 575371
Unscrew the system screw (1) as far as it will go for:
• Tractor with an open (constant-current) hydraulic system (for additional information,
please refer to the tractor manufacturer's operating instructions)
• Tractors with LS pump and non-activated load-sensing system
Pos: 18.36.6 /BA/W artung/Load-Sensing/ Hinweis Einstellung i st vom Werk aus gegeben @ 63\mod_1 299738968068_78.doc @ 575344
Note
This adjustment is set when the unit leaves the factory.
Pos: 18.36.7 /BA/W artung/Load-Sensing/Sy stemschreube (1) ganz hereindrehen @ 63\mod_1299 738923981_78.doc @ 575317
Screw the system screw (1) as far as it will go for:
• Tractors with closed (constant pressure or load sensing) Hydraulic system (For more
information, please refer to the tractor manufacturer's operating instructions)
• Tractors with LS pump and message line that is connected
Pos: 18.36.8 /BA/W artung/Load-Sensing/ Hinweis Anschluß der Mel deleitung @ 63\mod_12997 38872411_78.doc @ 575290
Note
The connection (2) for the message line is under the hydraulic system screw.
Pos: 18.37 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165