Settings
199
Pos: 32.101.5 /Übersc hriften/Überschr iften 3/A-E/Einste llung Garnhalter @ 47\mod_ 1285054111875_78.doc @ 455539
10.8.5 Setting of twine retainer
Pos: 32.101.6 /BA/Ei nstellungen/Großpac kenpresse/Knoter/ Einfachknoter Raspe/ Garnhalter Einac hknoter Raspe Bild @ 47\mod_1285 055172921_78.doc @ 455565
Fig. 137
Pos: 32.101.7 /BA/Ei nstellungen/Großpac kenpresse/Knoter/ Garnhalter Text Einf achknoter / Doppelkno ter Raspe @ 47\mod_128505 3711171_78.doc @ 455513
Setting the twine driver
The function of the twine driver (5) depends on the position of its indentation opposite the twine
disc cleaner (7). The twine driver (5) has been set to a = 0-2 mm as a default setting ex works.
• If the indentation on the twine driver (5) is positioned too far forward (clockwise),
the twine cannot be snagged by the twine driver as it is being guided along by the
needle.
• On the other hand, if the indentation on the twine driver (5) is positioned too far
back (anticlockwise), the twine strand may become wound up on the knotter hook
or it may not be possible for it to be snagged by the knotter tongue.
Setting the twine driver (5)
The indentation of the twine driver (5) has to be located at the position shown.
Then:
• Undo the nut (4) until the nut (4) is flush with the thread end of the auger
• Undo the auger by means of a slight knock against the nut (4)
• Adjust to a = 0-2 mm by turning the auger
• Tighten nut (4)
Note
At least two tying processes must be performed to check for the correct position of the
indentation.
Pos: 32.101.8 /BA/- ----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
To Next Page
Loading...
