Operation
174
Pos: 30.53 /BA/Bedienung / Großpackenpresse/ Pick-up-Antrieb bei Schneidwerk XC @ 20\mod_123 8995043191_78.doc @ 225477
9.16 Pick-up drive with XC cutting system
Fig. 110
The torque is transmitted through a star ratchet to the drive chain of the Pick-up from the output
of the lower angular gear of the cutting system.
Pos: 30.54 /BA/Bedienung / Großpackenpresse/ Hinweis Nockenschal tkupplung angesproc hen @ 20\mod_1238994789425 _78.doc @ 225453
Note
As soon as the cam-type clutch responds, stop the tractor and reduce the speed until the
machine has cleared itself again. The cam-type clutch now automatically resumes its work.
An error message appears on the display of the control unit.
Pos: 30.55 /BA/Bedienung / Großpackenpresse/ Pick-up-Antrieb über Getriebe (ohne Schnei dwerk XC) @ 20\mod_123899514 1691_78.doc @ 225501
9.17 Pick-up drive over gearbox (without XC cutting system)
Fig. 111
The torque is transmitted by an angular gear from above through a universal shaft with overload
protection (star ratchet) downwards onto an angular gear.
Pos: 30.56 /BA/Bedienung / Großpackenpresse/ Hinweis Nockenschal tkupplung angesproc hen @ 20\mod_1238994789425 _78.doc @ 225453
Note
As soon as the cam-type clutch responds, stop the tractor and reduce the speed until the
machine has cleared itself again. The cam-type clutch now automatically resumes its work.
An error message appears on the display of the control unit.
Pos: 30.57 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
