Krone Big Pack 890 HS - Overload Coupling on Flywheel

Placing in Storage
275
Pos: 36.13 /Überschri ften/Überschri ften 3/U-Z/Überlastku pplung am Schwungrad @ 46\ mod_1282047883734_78. doc @ 445914
14.3.1 Overload coupling on flywheel
Pos: 36.14 /BA/Einlager ung/Großpackenpres se/Überlastku pplung am Schwungrad Hinweis @ 46\ mod_128204801815 6_78.doc @ 445940
Note
After the machine has been idle for long periods of time, the linings of the overload coupling (1)
may adhere to friction surfaces. Vent the overload coupling before use.
Pos: 36.15 /BA/Einlagerun g/Großpackenpres se/Überlastkupplung a m Schwungrad BYPY 890/1270/890 ( XC) @ 48\mod_1286255932 953_78.doc @ 459871
Procedure for types BiG Pack 890 (XC) BiG Pack 1270 (XC) and BiG Pack 1290(XC)
Fig. 198
• The overload coupling is on the flywheel (3)
• To vent it, release the nuts (2) on the overload coupling (1) until the disc spring (4) is
released
• Turn the universal shaft manually around once
• Afterwards, retighten the nuts crosswise until the setting dimension X = 16,9 mm is set
Pos: 36.16 /BA/Einlagerun g/Großpackenpres se/Überlastkupplung a m Schwungrad BYPY 1290 HDP(XC) BP 12130 @ 46\ mod_1282044788109_78. doc @ 445861
Procedure for types BiG Pack 1290 HDP/XC and BiG Pack 12130
Fig. 199
• The overload coupling is located on the flywheel (3)
• To vent it, release the nuts (2) on the overload coupling (1) until the compression springs
are released
• Turn the universal shaft manually around once
• Afterwards, retighten the nuts crosswise until the setting dimension X = 75.8 mm is set
(measured from the outer edge of the disc (4))
Pos: 37 /BA/-----Seitenumbruch------ @ 0\mod_1196 175311226_0.doc @ 4165