Commissioning
53
Pos: 16.4 /Überschri ften/Überschri ften 2/F-J/Höhenanpassung der Deichsel @ 17\mod_123 6255816988_78.doc @ 204061
4.1 Adjusting the drawbar height
Pos: 16.5 /BA/Sic herheit/Großpackenpres sen/Unvorhergese hene Inbetriebnah me_2 BiG Pack @ 17\mod_12362555715 19_78.doc @ 204032
DANGER! - Unexpected movements of the machine!
Effect: Danger to life, injuries or damage to the machine.
• Secure the machine against rolling away with wheel chocks and by applying the parking
brake
• Use suitable supporting blocks for supporting the machine
• There is a risk of crushing one's feet when cranking down the parking support
Pos: 16.6 /BA/Er stinbetriebnahme/Großpac kenpressen/Ei nstellung der Anhängehö he: @ 17\mod_1236255969019_7 8.doc @ 204082
Fig. 18
The drawbar can be adjusted optionally for top or bottom hitch.
Both in the "top hitch (a)" position and in the "bottom hitch (b)" position the machine can still be
adapted in height to the hitching height of the tractor (hitch or swinging drawbar).
Note
Before starting the adjustment, set the machine on the parking support and uncouple the
tractor.
To guarantee optimum working, the machine must be hitched horizontally. The cross member
onto which the axle is bolted serves as a reference edge.
Setting the hitching height:
• For the adjustment of the drawbar height the towing eye (2) can be adjusted in height by
loosening the screws (1)
• If this is not sufficient the side parts (4) can be adjusted in height by additionally loosening
the screws (3)
• For adjusting to bottom hitch the two side parts (4) are turned round
Pos: 16.7 /BA/War tung/Hinweis Anzugsmomen te beachten (siehe Kapite l Wartung „Drehmomente“ ). @ 26\mod_1245736259299 _78.doc @ 263361
Note
Mind the tightening torques (refer to chapter Maintenance “Tightening torques”).
Pos: 16.8 /BA/--- --Seitenumbruch-- ---- @ 0\mod_1196175311226_0. doc @ 4165
To Next Page
Loading...
